Increasing water impermeability and strength of floor screeds and plasters.
Preparing screed that endures to abrasion.
Making of rough rendering for good adhesion on smooth surfaces.
Cement based screeds, plasters,
Exposed concrete,
Contact us for other different surfaces.
Not applicable on wooden, chipboard plywood and metal surfaces.
Not applicable against negative water pressure.
Not applicable on terraces and drinking water tanks.
It should not be left bare under direct sunlight.
Appliable layer number: 2-3 layer.
Duration of mortar’s usability: 2 hours max.
Time to wait between layers: apprx. 6 hours.
Time to wait for applying ceramic over: 1-2 days.
Duration of gaining mechanic strength: 3 days.
Duration of becoming water impermeable: 7 days.
Full drying time: 48 hours.
Surface needs to be dry, clean, and durable.
Surface defects needs to be fixed with Fenix Repairing Mortar 24 hours before
Izodek Two Compound Half Elastic Sliding Isolation” application.
Multi porous surfaces such as exposed concrete and cement based plaster should be
wetted and waited until the water layer is gone so that the surface remains moist.
20 kg’s of dust compound should be mixed with 5 kg’s of liquid compound. It should
be mixed with a low-speed mixer for 2-3 minutes
until it gets homogeneous.
KMixture should be mixed again after resting for 2 minutes.
Izodek Two Compound Fully Elastic Sliding Isolation should be applied to the surface
for double layers with brush or a trowel. Every layer should be made vertically to
another.
6 hours should be waited minimum between layers.
Identified durations are valid in 20 °C floor or environment temperatures, in low
temperatures duration will be longer, in high temperatures duration will be shorter.
Dekan Boya ve Yapı Kimyasalları San.Tic.Ltd.Şti. is not responsible for application
errors that may occur if the product is used for purposes other than its intended use or
if the application conditions and recommendations mentioned above are not followed.
Environment temperature: between +5 °C and +35 °C
Cement and sand must be fresh in mixture
Gloves, protective glasses should be wore during application,
eye and skin contact must be avoided.
Fenix Binder 100 Latex should be mixed with clean water.
Fenix Binder 100 Latex’ rate to water is between 1:1 – 1:4
Fenix Binder 100 Latex’ ratio to water depends on special occasions
such as application area.
Prepared liquid mixture should be mixed with dry mixture.
Identified durations are valid in 20 °C floor or environment temperatures, in low temperatures
duration will be longer, in high temperatures duration will be shorter.
Dekan Boya ve Yapı Kimyasalları San.Tic.Ltd.Şti. is not responsible for application errors
that may occur if the product is used for purposes other than its intended use or if the
application conditions and recommendations mentioned above are not followed.
