It is used as a primer on the exterior of buildings, especially on surfaces with high water absorbency,
to increase adherence and water-repellent properties under silicone-added paint and coating materials,
and to reduce the consumption of topcoat paint and coating material.
It increases adherence on exposed concrete surfaces, especially before plaster applications.
It extends the working time of cement and especially gypsum based plasters.
It prevents rapid water absorption.
It is used in all buildings on exposed concrete surfaces with high water absorption, on walls and ceilings,
on cement and especially plaster-based plaster, to increase adherence and working time, and to prevent
water absorption.
Preparing the Surface: Any anti-adhesive materials such as dirt, mold and oil must be cleansed from the surface.
Deformities must be repaired on surface.
Surface should be dry and cleaned.
Application:
According to the desired consistency, it is mixed with a maximum of 50% water with the help of a low-speed
mixer and applied to the surface with a roller in a single layer.
It should be mixed with Fenix Exposed Concrete Primer during application.
Surface should be waited for full drying to apply plasterwork.
Not applicable on wet and moisturized surfaces.
• After the application of Fenix Super Exposed Concrete Primer, plaster and gypsum must be applied within 7 days at the latest.
• Drying time: 12 hours minimum.
Environment temperature: between +5 °C and +30 °C
• It should not be applied to surfaces that under frost hazard within 24 hours, frozen and melting
• It should be avoided in strong winds, areas that under direct sunlight or hot surfaces.
