On surfaces that are not solid and have plaster defects thicker than 3 mm. not applicable.
It should not be applied on surfaces with paint, ready-made colored plaster, sprinkled plaster or exterior coating.

• Environment temperature: between +5 °C and +30 °C
• It should not be applied to surfaces that under frost hazard within 24 hours, frozen and melting
• It should be avoided in strong winds, areas that under direct sunlight or hot surfaces

H• It can be used up to 4 hours.
• It can be fully dried up to 24 hours.
• Application thickness: 1-3 mm.
• Layer thickness that can be applied: 1,5 mm maximum (single layer coating)
• Waiting duration between layers : 2-3 hours.

• Surface should be clean, stable and humid.
• Cracks deeper than 3mm should be fixed with Fenix Repairing Mortar before Satin Putty application at least 72 hours ago.
• Surface should be humid before application, must be wet enough under hot and windy weather

Approximately 8,5 liters of clean water and 20 kg of Cement Based Satin Putty should be mixed thoroughly,
, preferably with a low-speed mixer or trowel until admixture becomes homogeneous.
The mixture should be rested for 10 minutes before usage.
Cement based satin putty should be applied to surface equally with a trowel.
It should be waited for 2-3 hours if application requires multi-layers. Total thickness should not be over than 3 mm.
Surface should be smoothed with a sandpaper after cement based satin putty fully dries up.
Identified durations are valid in 20 °C floor or environment temperatures, in low temperatures duration will be longer, in high temperatures duration will be shorter.
Dekan Boya ve Yapı Kimyasalları San.Tic.Ltd.Şti. is not responsible for application errors that may occur if the product is used for purposes other than its intended use or if the application conditions and recommendations mentioned above are not followed.

- It should be rested properly after Fenix Cement Based Satin Putty is mixed with water and mortar should be mixed thoroughly before application.
- No foreign materials such as lime, cement, plaster should be added. Immediately after the application, the surface should be smoothed with a steel spatula or trowel without allowing the material to set.
Surface should be kept moisturized for 2-3 days after application
After the full drying period, smoothing should be done with sandpaper.